RESULTS OF DETERMINATION OF DEPENDENCE OF ANGLE OF FRICTION OF BEE HONEYCOMB ON STAINLESS STEEL FROM TEMPERATURE

Authors

  • V.D. Khmyrov Michurinsk State Agrarian University
  • H.I. Burenina Michurinsk State Agrarian University
  • V.V. Mironov All-Russian Research Institute of Livestock Mechanization
  • A.M. Afanasiev Michurinsk State Agrarian University

Keywords:

beekeeping, wax, beebread, bee honeycomb, angle of friction

Abstract

The paper presents studies of the dependence of the friction angle of a bee honeycomb on stainless steel on temperature. The results of these studies make it possible to determine the angle of inclination of the stainless steel surface at which the free sliding of the honeycomb begins at various temperatures. In the article the technique of carrying out the experiment is given, as well as a general view of the laboratory installation on which the friction angle of the bee honeycomb of stainless steel was determined. The dependence of the influence of the temperature of a piece of a bee honeycomb on the friction angle on stainless steel is obtained and analyzed.

Downloads

Published

2017-03-04

Issue

Vol. 4 No. 1 (2017)

Section

TECHNOLOGIES AND MEANS OF MECHANIZATION OF AGRICULTURE

License

Copyright (c) 2017 V.D. Khmyrov, H.I. Burenina, V.V. Mironov, A.M. Afanasiev

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Most read articles by the same author(s)