АНАЛИЗ ЭНЕРГОЭФФЕКТИВНОСТИ РАБОТЫ СУШИЛКИ КИПЯЩЕГО СЛОЯ

A.B. Terentev; K.Y. Mokrousova; S.V. Chekaykin

ANALYSIS OF ENERGY WORK DRYER FLUIDIZED BED

Authors

A.B. Terentev Penza State Technological University
K.Y. Mokrousova Penza State Technological University
S.V. Chekaykin Penza State Technological University

Keywords:

grain dryer, biogas, passing gas, combustion, heat balance, energy efficiency

Abstract

The article considers the thermal processes occurring in the dryer «fluidized layer» that run on cheap and affordable fuel - biogas and associated gas.

Downloads

pdf (Русский)

Published

2014-12-11

Issue

Vol. 1 No. 4 (2014)

Section

TECHNOLOGY EQUIPMENT OF FOOD PRODUCTION

License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Similar Articles

A.A. Kurochkin, M.A. Potapov, SUBSTANTIATION OF THE DESIGN AND TECHNOLOGICAL SCHEME OF AN ENERGY-SAVING THERMAL VACUUM UNIT , Innovative Machinery And Technology: Vol. 9 No. 1 (2022)
M.A. Potapov, A.A. Kurochkin, JUSTIFICATION OF THE DESIGN AND TECHNOLOGICAL SCHEME OF THE EXTRUDER FOR PROCESSING RAW MATERIALS WITH HIGH HUMIDITY , Innovative Machinery And Technology: Vol. 8 No. 2 (2021)
A.A. Kurochkin, T.V. Sheptak, EVALUATION OF SOME PARAMETERS OF AN ENERGY-SAVING EXTRUDER , Innovative Machinery And Technology: Vol. 7 No. 4 (2020)
D.I. Frolov, T.V. Sheptak, STUDY OF THE FACTORS AFFECTING THE ENERGY EFFICIENCY OF THE EXTRUSION PROCESS OF WET RAW MATERIALS , Innovative Machinery And Technology: Vol. 7 No. 3 (2020)
D.I. Frolov, A.V. Chushkina, STUDY OF THE WATER-ABSORBING PROPERTIES AND HARDNESS OF AN EXTRUDATE BASED ON CORN AND OKARA , Innovative Machinery And Technology: Vol. 7 No. 1 (2020)
A.A. Kurochkin, M.A. Potapov, JUSTIFICATION OF THE DESIGN AND TECHNOLOGICAL SCHEME OF THE EXTRUDER FOR PROCESSING RAW MATERIALS WITH HIGH HUMIDITY , Innovative Machinery And Technology: Vol. 6 No. 3 (2019)
T.V. Zakharova, E.L. Maltsev, S.P. Ryabikhin, TUBE OVEN FOR STEAM BATH , Innovative Machinery And Technology: Vol. 3 No. 2 (2016)
Z. A. Bochkareva, INFLUENCE OF OAT FLOUR ON FUNCTIONAL AND TECHNOLOGICAL PROPERTIES OF CHOPPED MEAT PRODUCTS , Innovative Machinery And Technology: Vol. 2 No. 1 (2015)
E. P. Ivanova, DEVELOPMENT OF THE PRODUCTION LINE HOP-PUMPKIN LEAVEN , Innovative Machinery And Technology: Vol. 2 No. 3 (2015)
V.F. Nekrashevich, R.A. Mamonov, T.V. Torzhenova, I.V. Vorobyeva, A.M. Afanasiev, MATERIAL BALANCE OF THE HONEY BEE HONEYCOMB , Innovative Machinery And Technology: Vol. 5 No. 3 (2018)

<< < 1 2 3 > >>

You may also start an advanced similarity search for this article.

Most read articles by the same author(s)

N.E. Luzgin, V.V. Utolin, V.V. Kochenov, S.V. Chekaykin, RESEARCH OF DYNAMIC VISCOSITY OF THE MOLTEN BEESWAX , Innovative Machinery And Technology: Vol. 5 No. 2 (2018)
D.I. Frolov, S.V. Chekaykin, A.B. Terentev, RESEARCH OF THERMAL PROCESSES AT DRYING OF SOLID LOOSE MATERIALS IN AN ASCENDING STREAM OF PRODUCTS OF BURNING OF BIOGAS , Innovative Machinery And Technology: Vol. 4 No. 2 (2017)
K.S. Bogochanova, A.D. Turusova, S.V. Chekaykin, ANALYSIS OF THE EFFECTIVENESS OF THE IMPLEMENTATION OF THE QUALITY MANAGEMENT SYSTEM AT RUSSIAN ENTERPRISES , Innovative Machinery And Technology: Vol. 10 No. 1 (2023)